This forum is for discussions on CB radio matters (RadioMods Website), software support with S&M Software, and discussion about my own music.
warhorse wrote:HI Mr. Rick Ta for more feed back actually I found the pin on the CPU of j276 was around 0.64 of a volt, and on the air( ssb ) all over the shop. so to cut a long and uninteresting story short I have used the 2830' CPU in a mk1 Lincoln and the bargraph in that radio works fine very well on 28mhz dx
so the problem remains on the board.
Going by the diagram most of the avenues r tested from jp34 using a generated sig jp34 is the most active point and the bargraph'.
hamguy2 wrote:hey rick, the fellow from the trucksite has asked me to ask you is there anymore parts involved with the 200gtl clarifier or is it just that certain crystal or xtal 2 you said any resistors or caps or is it just the xtal, thanks david nsw australia
warhorse wrote:Hi, all these replies spoiling me you r'' J34 is on the main president lincoln board its a wire link that supports the rx circuit to the 1st mixer i.e. q101. like u say using a sig gen and a scope for component checking should find the fault as of yet i have not located this annoying fault with this process.
Users browsing this forum: No registered users and 2 guests