The Defpom Forum, for RadioMods, S&M Software and Music by The Defpom

Can anyone tell me the poor man's way to do this with the least cash outlay?

take it to shop or send via ups or fedx that has all the proper equipment to do it

Hi Dennis,
It would help if you told us what the radio is, then someone might have the answer your looking for .

Dave.

Sure, Dave, the radio is the hygain v with the PTBM036AOX board.

hi ya matey....I too have been asking ths question ,,,,but have had no replies.....if you get one will you email or message me,,,,,and i`ll do the same .......
cheers
darren

The problem is, without proper equipment, you have little chance of aligning a radio. To completely align a radio, you need a wattmeter, signal generator, sinad meter, oscilloscope, frequency counter and a 50ohm non inductive dummy load at bare minimum.

You can do a basic power output alignment with just a good peak-reading wattmeter and dummyload, but thats gonna be about the limit as to what you can do.