For discussions on CB Radio Alignment and Tuning
5 posts • Page 1 of 1
I just got an old HR2510 and was checking it over to make sure it is ok.When checking the bias on the driver and final I notice that it is almost impossible to set the bias to 50ma on the driver, seems to be erratic, I cleaned up the VR but its still the same, the final is bang on just the driver seems to be so touchy, any ideas?
- Light User
- Posts: 101
- Joined: Monday 20th Oct 2008, 22:16
- Location: sydney australia
hi so you know if you stick a pair of mrf477s in them theyll do 100 watts ssb easy same as the htx 100 same chip. but its not all mode you can put lsb back in the htx 100 also am etc but a fair bit of work needed ,thanks hamguy2 nsw australia