MC145106 MM55106 MM55116 MM55126 PLL Frequency Synthesizer

Overview

The MC145106 is a phase?locked loop (PLL) frequency synthesizer constructed in CMOS on a single monolithic structure. This synthesizer finds applications in such areas as CB and FM transceivers. The device contains an oscillator/amplifier, a 1024 or 2048 divider chain for the oscillator signal, a programmable divider chain for the input signal, and a phase detector.
The MC145106 has circuitry for a 10.24 MHz oscillator or may operate with an external signal. The circuit provides a 5.12 MHz output signal, which can be used for frequency tripling. A 512 programmable divider divides the input signal frequency for channel selection. The inputs to the programmable divider are standard ground?to?supply binary signals. Pull?down resistors on these inputs normally set these inputs to ground enabling these programmable inputs to be controlled from a mechanical switch or electronic circuitry.
The phase detector may control a VCO and yields a high level signal when input frequency is low, and a low level signal when input frequency is high. An out?of?lock signal is provided from the on?chip lock detector with a ?0? level for the out?of?lock condition.
 Single Power Supply
 Wide Supply Range: 4.5 to 12 V
 Provision for 10.24 MHz Crystal Oscillator
 5.12 MHz Output
 Programmable Division Binary Input Selects up to N=512
 On?Chip Pull?Down Resistors on Programmable Divider Inputs
 Selectable Reference Divider, 1024 or 2048 (Including ? 2)
 Three?State Phase Detector

Down-converting of the frequency to the divider

This PLL Circuit use a Mixer and a X-Tal Oscillator to convert the output frequency f OUT to the f IN to the PLL Circuit.
The X-Tal frequency is f XTAL = f OUT - f IN
The output frequency can be changed by changing the mixing-xtal or add a new mixing-xtal to the oscillator.

PinNameDescription
1VDDPositive Power Supply
2F inFrequency input to programmable divider - Max. 3MHz
3OSC inOscillator input
4OSC outOscillator output
5F outReference OSC frequency divide by 2 output
6FSReference Oscillator Frequency Division Select. 1=10 kHz, 0=5 kHz
7D outDetector output (for control of external VCO)
8LDLock Detector
9P8Programmable inputs (Binary)
10P7Programmable inputs (Binary)
11P6Programmable inputs (Binary)
12P5Programmable inputs (Binary)
13P4Programmable inputs (Binary)
14P3Programmable inputs (Binary)
15P2Programmable inputs (Binary)
16P1Programmable inputs (Binary)
17P0Programmable inputs (Binary)
18VSSGround

TRUTH TABLE
P8P7P6P5P4P3P2P1P0Divide by N
0000000002
0000000013
0000000102
0000000113
0000001004
0000001015
0000001106
0000001117
0000010008
----------
----------
011111111255

This counter shows the number of hits since the 29th January 2000

Go Back To The Components Page

Go Back To The Main Home Page


Copyright © The Defpom 1997-2008

https://www.radiomods.co.nz/