The Defpom Forum, for RadioMods, S&M Software and Music by The Defpom

tring to wire a astatic road devil mic to a lafayette 625-a. have it wired as astactic said. 1-white 2-blue 3 shield 4 red. it will not key unles i grd. the white. could it be that the road devil will not work on relay switching??? thanks for looking the junkman no . thanks mike gues there are no m...

tring to wire a astatic road devil mic to a lafayette 625-a. have it wired as astactic said. 1-white 2-blue 3 shield 4 red. it will not key unles i grd. the white. could it be that the road devil will not work on relay switching??? thanks for looking the junkman

someone has used my name. i did not post this

is the freg to set in the glen the same on the mrkII as it is on the mrkIII. the mrkIII is 10.965. don't know about the II. thanks the junkman

There are 3 Browning MK III radios, the Eaglette III, Golden Eagle Mark III, and SST III. The problem sounds like a weak Oscillator. If the radio is Golden Eagle Mark III. Check the supply voltage at pins 1 and 6, of V1 (12AX7) and which should be about 150 VDC ? 10%. Check the output of tube V1 pi...

is that any better or need more info??

cannot get trans on freq when on the crystals. only way i can is when i use the glen. the freq counter just jumps around all over the place. i have tried to tune till i'm blue in the face. hope someone can help. junkman p.s. the vfo on the trans will not put it on freq. i changed the air cap. it wii...

all of a sudden the trans went way off freg. pwr and mod good. looks to be off at least 20-30 kc. can any help and tell me if there is an adjusment to set it back on?? thanks. the junkman

need help on hooking up a glen to a mrk iv-A . is there a way to do it and if so how. thanks the junkman

ghris, i see you have time to answer these but you don,t have time to answer your phone or reply to emails from your customers. you've had charlies browning for 5 monthhs and no replys after numerus attemptsit would be in your best interest do do this. jack the junkman

chri i se you have time to answer tese but won't take time to answer a customer that you,ve had his browing for over 5 MONTHS